Winco TPH241 - Manual

5
3
12
13
4
1
2
9
11
7
8
6
15
MOUNTING GENERATOR TO BASE
ATTACH HITCH KIT TO TRACTOR 1.
SET GENERATOR ONTO BASE AND SLIDE MOUNTING 2.
BOLTS (ITEM #15) INTO HOLES.
RAISE HITCH KIT TO A DESIRED LEVEL TO THREAD 3.
NUTS (ITEM #11) ONTO MOUNTING BOLTS
TORQUE MOUNTING BOLTS TO 40FT. LBS 4.
ASSEMBLY
MOUNT RUBBER FEET TO BOTTOM OF SUPPORT ARMS 1.
AND BASE (#'S 6,7,8) WITH 1" BOLT AND FLANGE NUT.
ASSEMBLE LEFT AND RIGHT SUPPORT ARMS (ITEM #'S 6 2.
& 7) WITH ARM TIE (ITEM #5) AND SUPPLED HARDWARE
(LEAVE BOLTS LOOSE)
ASSEMBLE BASE ONTO SUPPORT ARMS ACCORDING 3.
TO DETAIL "A" WITH 1" BOLTS AND FLANGE NUTS
GO BACK AND TIGHTEN ARM TIE TO SUPPORT ARMS 4.
MOUNT DRAW PINS (#4) TO SUPPORT ARMS (LOCK 5.
WASHER PLACED INSIDE ARMS)
ATTACH LYNCH PIN W/ CHAIN TO LEFT SUPPORT ARM 6.
(#7)
10
* - PARTS ARE IN SHEET METAL KIT 300240-8
A
5
7
6
8
DETAIL A
NOTE:
SUPPORT ARMS ARE
SET INSIDE OF BASE
BOM Table
ITEM NO. PartNo DESCRIPTION QTY.
1 350470 HEX NUT 7/8-14NF 2
2 350020 LOCK WASHER 7/8" 2
3 300209 PIN, TOP LINK 1
4 300208 PIN, DRAW 2
5 * 300240-4 ARM TIE 1
6 * 300240-3 RIGHT SIDE SUPPORT 1
7 * 300240-2 LEFT SIDE SUPPORT 1
8 * 300240-1 BASE 1
9 300212 ISOLATOR, NEOPRENE, 40 DURO 4
10 48178-000 HHCS 1/2-13 X 1 18
11 16248-001 .5-13 FLANGE NUT 22
12 300211 LYNCH PIN W/ CHAIN 1
13 300210 LYNCH PIN 2
14 300228 TUMBLE BAR 1
15 57580-000 .5-13X1.5 HHCS 4
REVISIONS
REV. IRN DESCRIPTION DATE BY APP'D
B 2408 UPDATED MODEL INFO. ON PRINT 1/2/2014 PJY DRC
C 2447 ADDED SHEET METAL KIT INFO. FOR SHEET METAL PARTS 1/21/2014 PJY DRC
UNLESS OTHERWISE SPECIFIED
ALL DIMENSIONS GIVEN IN INCHES
WORK TO DIMENSIONS FLAT OUTSIDE VIEW
SHOWN UNLESS NOTED -DO NOT SCALE-
FRACTIONS
1 PLACE DEC. .1
2 PLACE DEC. .015
3 PLACE DEC. .005
CHK'D BY ENG APPR.
TITLE:
MACHINED
SURFACE
TEXTURE
TPH241 INSTRUCTION SHEET
ANGULAR
1.5
DATE DATE DATE SCALE DRAWN BY
ASSY:
MODEL:
FINISH:
PART NO.
RLC
THIS DRAWING CONTAINS
PROPRIETARY
INFORMATION BELONGING
TO WINCO,
UNAUTHORIZED USE IS
PROHIBITED
MATERIAL:
10/11/201
0
TPH241
R
300241-100
300241-100