Winco 1B40 - Manual (Page 12)

4.3. Stopping the engine
Speed adjuster, standard version
– Move the speed adjustment lever „1“ back
to the STOP position. The engine cuts out,
Fig. 13.
Note:
Engines with a fixed lower idling speed cannot
be switched off using the speed adjustment
lever. See the paragraph entitled „Other ways of
switching off the engine“.
Speed adjuster with pull rod
(optional extra)
– Move the speed adjuster to the „STOP“ posi-
tion and press it until the engine cuts out,
Fig. 14.
Other ways of switching off the engine
1. Fuel shut-off valve, stop solenoid
(optional extra)
– Turn ignition key to the 0 position. The engine
cuts out, Fig. 19 and Fig. 20.
2. Stop pin (optional extra)
– Press the stop pin „2“ until the engine cuts
out, Fig. 13.
– Once the engine has cut out, release the
pin „2“ and ensure that it returns to its initial
position.
Depending upon the model, the battery charge
indicator „2” and oil pressure warning indicator
„3“ will come on again after the engine comes to
a stop, Fig. 19 and Fig. 20.
– Turn the key to position 0 and remove it.
All the indicator lights must go out, Fig. 19
and Fig. 20.
Note:
Failure to return the starter key to position 0
may result in the battery being totally
discharged.
If operation of the engine is inter-
rupted for any reason, or at the end of
the working day, the starter key should be kept
out of reach of unauthorised persons.
11