Winco Mfg. 6990 XL Nocturnal Recliner - Manual (Page 7)

OPERATING INSTRUCTIONS (cont'd)
6
LOCK/ UNLOCK CASTERS (Total-Lock vs. Directional)
1. Total-Lock casters will lock wheel and swivel mechanism
by using your foot & pushing down on the tab. Both front
and the right-rear casters are Total-Locks. These are
identified with lighter gray tabs.
Directional caster is used to help steer the chair (Left rear
only). The tab locks the swivel mechanism; The wheel
does not lock on this caster. It is identified with a darker
gray tab. (FIG. 1)
2. Release the locking mechanisms by pushing the above
described tabs back to horizontal position.
(FIG. 2 to FIG. 1)
TO POSITION SIDE TABLE
1. To raise table, grasp center of table and gently raise into
place. Table will automatically lock into place when
released. (FIG. 3)
2. To lower table, grasp table at the center, raise and pivot
down in one movement.
TO POSITION PIVOT TABLE
1. To adjust the pivot table position, loosen the adjustment
knob and swing away or place in the "lap" position. Tighten
knob to secure position. (FIG. 4)
2. To remove pivot table from chair, loosen the adjustment
knob and pull up on pivot table.
DO NOT lean or sit on side tables. Tables may
break and cause injury.
DO NOT allow patients to raise from chair using
side tables.
DO NOT allow weight to be placed on open
swing-arms. Arms may become damaged and fail
to close or latch properly.
SWING-ARM OPERATION
FIG. 3
FIG. 1 FIG. 2
FIG. 4
TO OPEN: Depress red latch handle to unlock Swing-Arm
TO CLOSE: Push Swing-Arm into latch.
Latch will automaticallly engage.