Winco Mfg. 8910SH - Bariatric Treatment Table - Manual (Page 2)

Page 2 of 4
006190 REV O Date 06-06-12 JWC
3. Secure the middle Table Leg to the Table Frame Rails with (2) ¼-20 x 2-1/2” screws & locknuts. Then, insert
(2) ¼-20 x 2” screws through (2) holes in each Upper Leg Brace and into (2) threaded holes in the wood of
the Upholstered Top.
IMPORTANT: DO NOT fully tighten at this time.
Cross-Braces (2):
4. Cross-brace to End Legs: Place (4) ¼-20 x 1-½” screws into the holes in the Lower Leg Braces and
through the holes on the Cross-braces. Install locknuts (hand-tighten). Heads of screws should face the
ends of table, for better appearance.
5.
Cross-brace to Center Leg: Place (2) ¼-20 x 2” screws into the holes in the Lower Leg Brace and through
the holes in BOTH of the Cross-brace. Install locknuts.
6. TIGHTEN ALL nuts & bolts holding the Table Legs to the Table Frame Rails.
7.
Install the six (6) Glide Feet into the threaded ends of the table legs.
Additional instructions for 8910 models ----- (8900 model go to step 12)
8. Attach the Face Slot Tube so that one hole is aligned with the center hole of the Upper Leg Brace, (flat side
of Face Slot Tube faces table bottom).
9. Position the opposite end of the Face Slot Tube over the 1” nylon spacer and the hole in table bottom. Install
two (2) 1-3/4” Panhead Phillips screws through both ends of the Face Slot Tube, then tighten into the
upholstered table top with a Phillips Head Screwdriver.
10. Install Face Paper Holder using (2) 1” black drywall screws in pre-drilled holes on either side of Face Slot.
11. Install Face Paper Cutter on Table Frame Rail (where desired) opposite Face Paper Holder. Peel backing
from tape on back and press cutter firmly into place.
12. Using at least two people, turn table upright.
13. Place
Paper Holder Rod, with paper roll installed, through the (2) Paper Rod Clamps.
14. Adjust the Glide Feet to level the table.
Optional Shelf installation:
15. Double-sided tape has been installed on the top of the Cross-braces.
16. Before removing paper on tape, “test fit” the shelf. Shelf should be centered between outside Table Legs.
17. Once you are certain of where you will position the shelf, peel off the paper to expose adhesive.
18. Carefully position shelf in place on adhesive.
Wrinkles in Vinyl – Storage and shipping can cause wrinkles of the vinyl on your Winco table. This is normal.
Please allow 1-2 weeks at room temperature (approx. 70 degrees) to allow for vinyl to expand back to original
appearance.
Before installing:
Make sure that the smooth surface of the welds on the Cross-Braces will face upward (when the table is in
the upright position) prior to fastening to Lower Leg Brace of Table Legs. (IMPORTANT for best appearance
and proper shelf installation)
HINT: After peeling paper from adhesive tape use damp sponge to moisten tape to allow face paper
cutter to be adjusted during install. Once tape is dry face paper cutter will stay in place.
Do not over tighten nuts and bolts. Periodically check all fasteners for tightness.
HINT: After peeling paper from adhesive tape use damp sponge to moisten tape to allow face paper
cutter to be adjusted during install. Once tape is dry face paper cutter will stay in place.