Harbor Freight Tools Model 94245 User Manual

Page 13

Advertising

Page 13

For technical questions, please call 1-800-444-3353.

SKU 94245

or clamp a straight edge to the material

to guide the saw on a straight path.

Refer to photo above.
Place the saw Base Plate on the material

to be cut. Align the front notch (right

edge aligns with saw blade) on the cut

line.
Hold the Circular Saw by both handles.

Always keep hands and fingers away

from the Saw Blade.
Push in and hold the Switch Lock Button,

then squeeze the Switch (61) Trigger

with the index finger. Do this before the

saw blade touches the material.
With the saw at full speed, move the saw

slowly forward to complete the cut.
When the cut is complete, release the

10.

Trigger. Do not set the saw down until

the blade stops turning.
To prevent accidents, turn off the tool

11.

and disconnect its power supply after

use. Clean, then store the tool indoors

out of children’s reach.

pocket Cuts

Tilt the saw forward with the cutting

guide notch of the Base Plate on the line

drawn for the cut.
Raise the Blade Guard (20) with the

Blade Guard Lever (35).
With the Saw Blade just above the

material to be cut, start the saw and

allow the Saw Blade to come to full

speed.
Gradually lower the Saw Blade onto the

stock using the front end of the Base

Plate as a pivot point.
When the cutting begins, release the

Blade Guard.

When the Base Plate is resting flat on

the stock being cut, proceed cutting in a

forward direction to the end of the cut.
When the cut is complete, release the

Trigger and wait for the Saw Blade to

come to a stop before lifting the saw out

of the cut.
If necessary, complete the cut from the

opposite direction in the same manner

described above.
WARNINg! Never pull the saw

backwards since the Saw Blade will

climb out of the cut and kickback will

occur.
When the cut is complete, release the