Vermont Casting DEFD36 - Manual (Page 11)

11 10005898
Vermont Castings, Majestic Products, DEF33/36, DEFD33/ 36
Operating Instructions
1. Main ON/ OFF Switch
The ON/OFF switch supplies power to all functions of
the fireplace. This is an illuminated switch that normally
lights up when in the ON or OFF position.
The control compartment is located behind the panel
access Radiant. To access the controls, simply flip
down the panel access Radiant. Refer to Fig. 8, below,
to locate the position of each control.
During any service of this appliance, the
power to the unit must be turned off. It is
not acceptable to use the ON/OFF switch
to meet this requirement.
2. Heater Control
The Heater Control acts to turn the heater ON and OFF
as well as setting the comfort level in the room. Turning
the knob clockwise from the OFF position will place the
heater into operation. The further the knob is rotated
clockwise, the higher the set point temperature. Turning
the knob counter-clockwise will lower the set point
temperature. Turning it all the way counter-clockwise
will turn the heater function OFF.
Turn the flame speed control knob to increase or
decrease the flame speed as desired.
Control Panel
3. Flame Speed Control
FP1210
Fig. 8 Control panel
GOLD GOLD
GOLD
10005509 I'avant de I'appareil de chauffage.
soient a au moins 3 pieds (0,9m) de
tentures et autres textiles domestiques
veiller a ce que les cordons electriques,
AVERTISSEMENT: Risque d'incendie,
d'alimentation avant le service.
AVERTISSEMENT: Debrancher la source
des details sur le service.
Voir les instructions d'installation pour
heater.
least 3 feet (0.9m) from the front of the
cords, draping, and other furnishings at
WARNING: Risk of fire, keep electrical
Servicing.
WARNING: Disconnect Power Before
details.
See Installation Instructions for service
ON/OFF
LEARN
RED
3 2 1 5 4
4. Re-learn
This model fireplace with integral remote control has
a preprogrammed, matched-pair Receiver/Transmitter
already set with randomly-selected house codes.
It is highly unlikely that the fireplace code will ever need
to be re-learned. If the fireplace needs to re-learn
Receiver/ Transmitter house codes, perform the
following steps:
1. Be sure there is power to the fireplace.
2. Be sure there is a good battery in the Transmitter
(hand-held remote).
3. Open the battery compartment of the remote.
4. Press and release the small button located in the
top left corner. This will randomly select a new
house code in the remote Transmitter.
5. Close the remote Transmitter battery compartment.
6. Press either the ON or OFF button on the Remote
Transmitter, and the Learn button on the fireplace
at the same time. The fireplace is now ready to
accept commands from the remote Transmitter.
5. ON/OFF
The ON/OFF button on the fireplace (below the Learn
button) is to turn the fireplace ON and OFF when the
battery in remote Transmitter is weak, or to manually
operate the fireplace without the remote Transmitter.
NOTE: The device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference, and;
2. This device must accept any interference
received, including interference that may
cause undesired operation.