Canon 220EP - Manual (Page 36)

32
12.
Clearing a Paper Jam or Double Feed Error
If a paper jam or double feed error occurs, feeding and
scanning operations are paused, and an error screen similar to
the following appears.
When this occurs, clear the paper jam (or document that
stopped mid-feed) and perform one of the following
procedures.
• To continue scanning, reset the document starting with the
page that stopped mid-feed, and then press [Resume]. The
reset document will be scanned, and the Preview screen will
appear when the entire document finishes scanning.
• To cancel scanning, press [Cancel]. The portion of the
document that was scanned before the error occurred will be
displayed on the Preview screen.
Hint
Double feed errors will only be detected if [Double Feed Detection]
is enabled in the Scanning Settings for the device.
IMPORTANT
• If double feed errors occur repeatedly, reduce the number of
sheets you place in the document feed tray to about 10.
• A dirty or worn feed roller, or documents stuck together as a result
of static electricity are common causes of paper jams or double
feed errors.
If the feed roller is dirty, clean it. If paper jams or double feed
errors continue to occur even after cleaning, contact the
ScanFront administrator and replace the rollers (feed roller and
retard roller), and document holding guides.
❏ Removing the Jammed Document
Remove a jammed document (or document that stopped
mid-feed) from the scanner as follows.
1. Remove the scanned documents from the document
eject tray, and any documents remaining in the
document feed tray.
2. Pull the lock lever toward you and then fully open the
panel unit.
Type of error
Lock lever