How to replace the brushes, Shaft, End assembly – Hoover CONVERTIBLE U4057 User Manual
Page 17: Locator, How to replace brushes, Shaft end assembly
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
How to replace the brushes
Disconnect the cleaner from electrical outlet.
1. To replace worn brushes, remove bottom plate, belt and agitator, following
directions given on preceding pages.
2. Turn end plates of agitator in
opposite directions to loosen.
m
I
j £■'
END
SECTION
END PLATE
3. Continue turning until one end
comes off exposing the end section.
Then, pry out end section exposing
the shaft.
SHAFT
END
ASSEMBLY
4. Gently tap the end of the shaft
with hammer to loosen opposite
end.
5. Puli shaft and end assembly from
agitator.
LOCATOR
6. Remove brushes by pulling them
from agitator. Slide new brushes
into channels. Push them in as far
as possible.
7. To reassemble, replace shaft and
end assembly lining up the locator
with the slot in the agitator. Press
into place. Place remaining end sec
tion over the shaft end, lining up the
locator and slot. Press into place.
Screw end plate on and tighten.
16