Sony HT-DDW675 - Manual (Page 37)

Error messages
If there is a malfimetion, the display shows a
message. You ean eheek the eondition of the
reeeiver by the message. Refer to the following
table to solve the problem.
DEC. EROR
Appears when the signal whieh the reeeiver eannot
deeode (ex. DTS-CD) is input when “DEC. XXXX”
is set to “DEC. PCM”. Set to “DEC. AUTO”.
PROTECT
Irregular eurrent is output from the speakers. The
reeeiver will automatieally turn off a^er a few
seeonds. Cheek the speaker eonneetion and turn on
the power again. If this problem persists, eonsult
your nearest Sony dealer.
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the reeeiver’s memory may remedy the
problem (page 15). However, note that all
memorized settings will be reset to their faetory
settings and you will have to readjust all settings
on the reeeiver.
If the problem persist
Consult your nearest Sony dealer.
Reference sections for clearing
the receiver’s memory
Specifications
To clear See
All memorized settings page 15
Customized sound fields page 27
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
With 6 ohm loads, both ehannels driven, from
120 - 20,000 Hz; rated 70 watts per ehannel
minimum RMS power, with no more than 0.7%
total harmonie distortion from 250 milliwatts to
rated output.
Amplifier section
Power Output 1)
(6 ohms 1 kHz, THD 10%)
FR0NT
2) : 110W/eh
CENTER 2) : 110 W
SURR 2) : 110 W/eh
1) Measured under the following eonditions:
120 VAC, 60 Hz
2) Depending on the sound field settings and the
souree, there may be no sound output.
Inputs (Analog)
SA-CD/CD, DVD,
VIDEO 1, 2
Sensitivity: 800 mV
Impedance: 50 k ohms
Inputs (Digital)
DVD (Coaxial) Sensitivity: -
Impedanee: 75 ohms
SA-CD/CD (Optieal) Sensitivity: -
Impedanee: -
Outputs (Analog)
SUB WOOFER Voltage: 2 V
Impedance: 1 kohm
>
Q.
Q.
5'
3
3
Reproduetion frequeney range:
28-20,000 Hz
Tone
Gain levels ±6 dB, 1 dB step
continued m
37 US