Citizen Systems CD-S500A - Manual (Page 22)

22
Chapter3 Preparing the Printer
Connecting the Power
1
. Make sure that the printer power
switch is set to OFF.
2
. If your printer is an AC adapter type,
insert the AC adapter cable connector
with its flat side upwards into the
power connector on the rear surface
of the printer.
If your printer is a built-in AC adapter
type, insert the plug on the power
cord into the AC inlet on the back
surface of the printer.
AC adapter cable
Flat side of the cable is up.
AC adapter type
AC inlet
Built-in AC adapter type
Do not use an AC
adapter other than
the stipulated product
(Model 51AD).
Always hold the connector when
inserting or removing the cable
connector of the AC adapter.
Stretching the power cord by pulling
it will damage it, causing fire, electric
shocks, or a break in the conductor.
When lightening is striking nearby,
remove the plug of the power cord
from the outlet. Lightening will cause
fire or electric shock.
Do not place the power cord near a
heating device. The cover of the power
cord will melt, causing fire or electric
shock.
When the printer will not be used for
a long period, be sure to remove the
plug of the power cord from the outlet
to guarantee safety.
Isolate the AC power source from
other devices that generate noise.
Caution
DC 24V
51 AD
ONLY