Flex FLE Roof Edge User Manual
Flexiock fle roof edge
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Flexiock FLE Roof Edge
Fully Adhered or Mechanically Attached Single-Ply and Built-Up or
ModifiedVersion
Warranty:
The entire roof system is covered under one warranty and inspected after the project is complete to
assure proper installation. The system is inspected after the project is complete to assure proper
installation. This ensures protection for the most vulnerable area of the roof against failure due to
extreme wind up lift pressures.
Testing:
• Tested per ANSI/SPRI ES-1 Standard to a design pressure of 290 Ibs./fP to comply with the
International Building Code.
• Factory Mutual 1-645 approved for wind up lift protection.
• Miami-Dade Approved (No. 08-0604.02 12/11/13) to comply with the “High Velocity Hurricane
Zone of the Florida Building Code”.
Standard Sizes:
Sizes range from 4" up to
8
Vz" face heights to accommodate multiple nailers and coverage
requirements.
. 4"
• 5
1/2"
•7"
•
8 1/2"
Anchor Bar Protection:
The patented, extruded aluminum anchor bar securely terminates the membrane. This provides
protection unlike any other manufactured or shop-fabricated edge. The anchor bar is readily available
to dry-in the roof structure.
Available Materials:
Covers can be manufactured in 24 ga. steel and .040" aluminum.
Watertight:
Its non-penetrating design eliminates the need for stripping-in or heat welding that is typical of
many other roof edge designs. Watertight integrity is not compromised by improper flashing
procedures, faded adhesives or lap sealants.
Competitively Priced:
The installed cost rivals even light gauge roof edge systems fabricated locally or in a roofer’s shop.
Efficient Design:
The product is provided in
12'-0" lengths with pre-punched holes for quicker installation and lower
labor costs. The fastening holes are slotted to allow for proper thermal movement of the materials
and ensure correct fastener placement and spacing.
Colors:
Choose among a wide range of standard colors and finishes that meet your job requirements. A
20
year Kynar 500® finish warranty is included on standard colors. Custom post-coated Kynar 500
colors are avaUable with an included 10 year Kynar 500 finish warranty or a 20 year Kynar 500 finish
warranty is avadable upon request. Anodized finishes are also available, but are not warranted.
Custom Capabilities:
Radius and specially fabricated products are available to meet the unique needs of each project.
Accessories:
Factory fabricated miters, scuppers and drainage accessories provide a cleaner, more aesthetically
pleasing appearance.This eliminates the need for field fabrication, providing time and labor savings.
Also Included:
All anchor bar EPDM splice plates and fasteners are included and wih arrive to the job site with the
product (sealant by others).
Reusable/Recyclable
Material:
When reroofmg the anchor bar can be removed, cleaned and reinstalled at any time without
compromising its strength and appearance.
featyres & benefits
p: 800-969-0108
f: 610-916-9501