Changing the lithium battery – Emerson SMARTSET CKS3029C User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

;

H B*'i

Ж

L

-ф-

CHANGING THE LITHIUM BATTERY

Like all batteries, eventually the built in iithium battery will need to be replaced. A

number of factors, such as, the length of time between the date the radio was

manufactured and the date you plugged it in for the first time determine the amount

of time before replacement. During this initial storage period, the iithium battery is

supplying power to the SmartSet® computer memory. Once you plug the radio in,

your household outlet supplies the power, and the battery is not being used. A

fresh lithium battery can supply power to the SmartSet® computer for at least 3

years even if it is never connected to an AC power supply. If your radio was

connected to your AC supply within a few months after it was manufactured, and

you experience only the normal, nuisance type, short duration power interruptions,

your battery may last for up to 5 years or even longer.

When the battery power drops below a certain level, the LOW ВАТТ indicator will

‘flash'. When you see this indicator, you should change the battery as soon as it Is

convenient for you to do so. To change the battery proceed as follows:

1. ) Purchase a replacement 3V lithium battery wherever batteries are sold. The

battery type is CR2430 or equivalent.

2. ) Remove the battery from its package so it is ready to install.

IMPORTANT: Leave the radio power cord connected to your AC outlet. This

will provide power to the SmartSet® computer memory while the original lithium

battery is removed.

3. ) Turn the radio upside down and use a small screwdriver to remove the screws

securing the battery holder to the cabinet.

BE CAREFUL NOT TO LOSE THESE SMALL SCREWS!

4. ) Remove the original battery from

the holder and insert the new

battery into the holder the same

way, observing the positive (+)

direction. Slide the holder with the

new battery back into the slot in the

cabinet.

5. ) Replace the screws that secure the

battery holder in the cabinet.

6. ) Turn the radio right side up and confirm that the LOW ВАТТ indicator is ‘Off’.

7. ) Save these instructions. You’ll have to do this again five to eight years from

now!

17

CKS3029C__080106.p65

c4-

1/8/2006, 9:25

Advertising