Carrier 51CM - Manual (Page 12)

19 Vent and Exhaust Lever — See Vent and
Exhaust Level in Fig 20
a Remove exhaust dooi as desci ibed under Exhaust
Door
b Rotate levei upward while pushing lever out oi
mounting slot
c Reveise above procedure for leassembly
20 Evaporator and Condenser Coils — See
Evaporatoi and Condenser Coils in Fig 24 These
coils have copper tubing The interconnecting tubing
is designed as an integral pait of the coils to make
servicing easier
21 Strainer — The strainer is installed in the inter­
connecting tubing between the condenser and the
capillary tube To change the strainer
a Purge and remove all refi igei ant from the system
b Cut tubing one in from capillary tube insertion
point
c Use a thin piece of wire to remove strainer from
tubing
d Insert new strainer into tubing Reassemble with a
field-supplied 1 /4-in copper coupling
22 Test Run Unit — Plug unit into proper power
supply outlet Reiei to operating instructions in
Owner’s Handbook for Comfortable Living Check
all controls for correct operation, then unplug unit
If unit sounds noisy during test-run, it may be
because compressor spring-mount nuts have not yet
been removed See Compressor instructions (16 f)
A WARNING
Moving parts can cause personal injury Be care­
ful when test-running unit Do not operate unit
with Iront grille removed
CONDENSER
'COIL
EVAPORATOR
COILi
Fig 24 — Evaporator and Condenser Coiis
12