Clarity E814CC - Manual (Page 44)

44
Call from the CID
1. In idle mode, press <down> to access the CID. Alternatively, press <menU/
seLect> to access the CID from the main menu.
2. Press <UP/down> to select the desired CID entry.
3. Press <taLK on / fLash> or <sPeaKer> to dial out to the selected entry.
Call from the Redial List
1. In idle mode, press <rd/P> to access the redial list.
2. Press <UP> or <down> to select the desired redial number.
3. Press <taLK on/fLash> or <sPeaKer> to dial out to the
selected number.
note:
Your handset automatically times the duration of every call. The call timer will
display a few seconds after the call has been made. It is shown in hours, minutes and
seconds format.
Temporary Tone Dialing
If you have pulse (rotary) dialing service only, you can temporarily switch from pulse to
touch-tone dialing during a call.
During a call, press <*>. Buttons pressed after this send touch-tone signals.
The telephone automatically returns to pulse dialing mode after you end the call.
answer a Call
1. When the phone rings, press <taLK on / fLash> to use the earpiece
–OR–
2. Press <sPeaKer > to use the speakerphone.
end a Call
1. During a call connection on handset, press <taLK off/ cLear> to end the call.
–OR–
2. Put the handset on the base station to end the call.
Chain dialing
This feature allows you to initiate a dialing sequence from numbers stored in the
directory, CID or redial list while you are on a call.
Chain dialing can be useful if you wish to access numbers other than phone numbers
using your CorDless HanDseT