Lectronic atert ot uiagnostic oysrem ¡continued) – Sears 8EAIRS User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
lectronic Atert ot uiagnostic oysrem ¡continued)
The Electronic Alert and Diagnostic System
alerts you when something starts to go wrong
If a system code appears on the display,
something needs special attention.
To get your
attention, the display code flashes until you erase it
The first 6 flashes are accompanied by beeps.
If more than one coded function requires attention
ot the same time,
the one with the highest priority will
be displayed first.
Pressing the SYSTEM CHECK-RESET pad will evaluate oil
other coded functions If the NORMAL display is lit
during the displaying of o code, that function is operating
properly.
Pressing the SYSTEM CHECK-RESET pad will erase
two codes immediately—PF, and Cl
The DE and
FF codes can only be erased by touching the
SYSTEM CHECK-RESET pad after the condition
that coused the code to fiosh hos been corrected.
This flashing code tells you the
power to the refrigerator has
been interrupted
for more than
2 seconds. Check the condition
of food in both the fresh food and
freezer compartments Touch
oY I C/vt ^rj
I jiliOCi
to
erase code»
There is no fault with the refrigerator
when
PF code fleshes.
This flashing code tells you
something's wrong with the defrost
system—
keep doors closed to
retain cold and call for service.
Code flashes until problem is
corrected
This flashing code tells you
to
check your frozen food.
Has any of it started to thaw?
A package may be holding the
freezer compartment door open,
Don't open the door more often
than absolutely necessary while
this code is displayed Touching the
SYSTEM CHECK-RESET pad after the freezer
compartment temperature has returned to normal will
erase the code.
This flashing code tells you to
check the automatic icemaker.
Ice clumps in the storage bin may
have stalled the icemaker Follow
corrective measures described on
page 9. If wafer supply to the
icemaker is not connected or not
turned on, make sure manual
icemoker switch is in the STOP position, Code stops
flashing when problem is corrected or SYSTEM CHECK
RESET pod is touched