Jeaning dryer interior, Preparing your dryer for moving – Sears Clothes Dryer User Manual

Page 17

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

SECTION 4

Jeaning Dryer Interior

^WARNING

Electrical Shock Hazard

Turn off electrical power or
disconnect dryer from power supply
before cleaning the interior.

Failure to do so may result in
electrical shock or serious injury.

Clothes, such as denim blue jeans or
brightly colored cotton fabrics, that

contain unstable dyes may discolor
the dryer drum. If the drum is
discolored, clean it by one of the

following methods to avoid possible
stain transfer in later loads.

' Use powdered laundry detergent

and hot water.
Make a paste with the detergent and
hot water. Apply paste to a soft cloth
and scrub the discolored area until
excess dye is removed. Wipe
thoroughly with a damp cloth. Run the
dryer through a timed heated cycle for
20 minutes with a load of rags.

’ Use liquid spray household cleaner.

Spray cleaner on the stained area. Rub
with a cloth until excess dye is

removed. Run the dryer through a
timed heated cycle for 20 minutes with
a load of rags.

If It Seems That The Dryer Is Taking
Longer To Dry, It May Be Because:

' Unt screen is filled.
' Exhaust system is too long or has a lint

build-up.
Clothes rinsed in cold water need a
longer time to dry.

' Dryer is overloaded.

' Dryer is installed in a cold area.
■ Today’s new fabrics demand lower heat

settings.

' Dryer should not be operated in room

areas where temperature is below
45°F (7.2°C).

Preparing Your Dryer for Moving

GAS DRYER MODELS

1. Remove power cord from wall socket,

coil and tape to back of dryer.

2. Close shut-off valves in gas S^ply line

and behind dryer front access panel.

3. Disconnect gas pipe and remove

fittings that stick out from dryer.

4. Cap the open fuel line running to

gas meter.

ELECTRIC DRYER MODELS

1. Shut off electric supply to the dryer.

2. Remove pxrwer supply from wall

outl«tiW.discennect direct wire from
dryer’terminal block.

ALL DRYER MODELS

1. Make sure leveling legs are secure in

dryer base.

2. Apply filament tape from inside drum,

out the door opening to the front
panel to prevent drum movement.

3. Use masking tape to secure

clothes door.

17

Advertising