Installing radial drill press – Sears 149.213340 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7., Make sure bottom of Spindie Shaft (REF
42)
and bore of
Chuck (REF 46) are dean and free of grease. Press
Chuck up onto Spindle Shaft.
NOTE; To avoid damage to Chuck, rotate Chuck barrel
until jaws are fuily open.
8 Using a mallet or a block of wood and hammer, firmly tap
Chuck upward into position onto Spindle Shaft
INSTALLING RADIAL DRILL PRESS
A
WARNING;
B
efore
using
radial
drill
press
,
MAKE SURE IT IS ATTACHED TO A FIRM AND STABLE SUP
PORT SURFACE USING CARRIAGE BOLTS AND WiNG
N
uts
provided
.
12 3/4" Fore and Aft Travel
1.
Choose an area that allows sufficient clearance to take
full advantage of the Radial Drill Press's lateral, rota
tional, and tilt motions.
2.
Bolt Radial Drill Press to a firm and stable surface using
Carriage Bolts and Wing Nuts provided. Be sure bolts
pass entirely through mounting surface and are at least
5/16-18 standard strength. Tighten all bolts and wing nuts
securely.
3/8" Diameter
2 Holes
Head Tilts 45”
Clockwise and 90‘
Counter-clockwise
360’ Rotation
Use Carriage Bolls and
Wing Nuts Provided