Sears 564.89636 - Manual (Page 2)

Net Capacity 3.6 Cubic Feet*
MODEL 564.8963600
THINGS YOU OUGHT TO KNOW
WHEN YOUR REFRIGERATOR IS INSTALLED
INSPECT
For shipping damage. If damaged, or parts
missing, notify Sears at once.
INSTALLATION
Remove all packing material and tape.
Install on strong, level floor or counter.
Avoid any of direct sunbeam, heat source and
moisuture.
Let air circulate freely around refrigerator.
Keep rear of refrigerator 5 inches away from
wall and provide at least 12 inches space on top
for proper operation.
CAUTION
Should you turn off the cold control, allow at least
three minutes before restarting in order to give the
electric device cooling off time.
ELECTRICAL REQUIREMENTS
120 Volts, 60 Hz (60 cycles A.C.) 15 Amps
circuit.
ELECTRICAL GROUNDING
Must be grounded. Uses 110-120 Volt 60 Hz
(60 cycle) AC. Do not use extension cord. Use
three-prong plug with three-prong grounded
wall outlet.
Unless the above grounding method is followed,
you are not protected against severe or lethal
shock, in the event of a short circuit of an
electrical component or wiring of refrigerator.
^Capacity manufacturer certified
(Association of Home Appliance Manufacturers)
«oœocoooo<xxx>ixxxx>c<xxxxiocxji<>3oooococioooococoocooo3ocooGoocooo30üooG<x>cœoGioooooooocooi>ocZjj
§ USE AND CARE INFORMATION
o
® Tips on everyday care and use
To control temperature: Start by setting
control on middle position. Wait 24 hours
for refrigerator to cool. The closer to
MAX position is colder.
Fresh food section should be as cold as
possible without freezing vegetables or milk.
Adjust as necessary.
Defrost when freezer compartment builds
up 1/4" of frost. Turn off control. Remove
food. Do not use heater devices to speed
defrosting. Do not scrape or use sharp ob­
jects in freezer. Let frost melt. Pan of warm
water in freezer speeds defrosting. Empty
drip tray. Reset cold control. Replace
food.
For all cleaning: Mix 2 tablespoons baking
soda with 1 quart warm water. Or use mild
soap. No strong cleaners, scouring powder
or pads. For persistent odors. Sears Service
Department has odor removal products. Do
not put the drip tray in dishwasher. Vacuum
the tubing on outside back when dusty.
• Things to remember
1. Allow 24 hours for your Refrigerator to
reach a new temperature setting.
2. The motor will start and stop often. It
must, to maintain the temperature you
select.
3. Keep your refrigerator reasonably level.
4. Unplug refrigerator before doing any­
thing with electrical system.
• Before calling for service
Check plug and fuse. Test outlet with lamp.
Be sure control is on. Read all USE AND
CARE
INFORMATION. Your questions
may be answered. If not, find your model
number (on upper back of refrigerator).
Refer your number and problem to the
Service Department at your nearest Sears
store, or service center.
< DANGER — ELECTRICAL SHOCK HAZARD. Disconnect power before servicing. V
}<XXJC<XXXX>OOCOG<XXXXXXXX>GOOOO<X>G000030GOOOOOCOOOOCOOOOGOG<XX>COC<JOOOOOOOCG>OOOOCOOOOOOOOO<iOO
ENERGY SAVING TIPS
WAYS TO SAVE POWER, SAVE MONEY, AND STILL ENJOY YOUR KENMORE
1. Reduce door openings.
2. Close the door as soon as you can.
3. Keep coils on back of refrigerator clean.
4. Adjust temperature control to warmer setting when practical.
5. Don't put hot foods in refrigerator.
6. Don't allow more than 1/4" of frost to build up in freezer compartment.
7. Keep your Kenmore away from stove or other heat sources.