Installation – CDA WF140 User Manual
Page 15
Installation
•
Do not install this appliance if it is damaged in any way. Installing a
damaged appliance may invalidate the warranty.
•
The water supply tap should be located in an adjacent cupboard so that it
can be accessed after installation.
•
Ensure the appliance is level by adjusting the feet as necessary.
•
Only use the water inlet supplied with the appliance.
•
If the water pressure is above 10 bar, a pressure relief valve should be used.
•
After connecting the water supply, check to ensure there are no leaks.
•
The water outlet can either be connected to a water drain or to a sink outlet
spigot. This connection should be at a minimum of 50 cm and a maximum
of 110 cm from the floor. The drain hose should be no longer than 4m in
length to ensure good performance from the dishwasher.
fig 14
fig 15
fig 16