Sears 74781 - Manual (Page 3)

CYCLE SELECTOR CONTROL
AUTO DRY I Cycle
Use this cycle for most loads, it gives the best drying in the shortest time.
Drying time varies according to type of fabric, size of load and dryness
setting.
Dryness is determined by thermostats that react to the amount of moisture
in the air exhausted from the dryer. When the dryness selected is reached,
the dryer goes into cooldown for 10 minutes (approx.) then a buzzer
sounds. If you do not unload the dryer, it goes into Wrinkle Guard I
automatically.
• Set the Cycle Selector Control to the (#) which is good for most fabrics.
You can set the control for MORE DRY if clothes are still damp at the
end of the cycle or LESS DRY for clothes that are too dry or are to be
ironed.
• Set the Heat Temp Control to the type of fabric in the load.
• Push the Start Control.
AIR DRY Cycle
Use this cycle to get up to 30 minutes of drying time in room temperature
air. Use this setting for items that will not tolerate heat, such as plastics,
foam rubber, etc. and for airing and fluffing items such as pillows.
• Do not use heat to dry these items.
• Set the Cycle Selector Control for the number of minutes you want in the
AIR DRY Cycle.
• Push the Start Control.
TOUCH-UP Cycle
Use this cycle to “smooth” synthetic and permanent press clothes that are
clean but wrinkled from being crowded in a closet or suitcase. This setting
provides about 15 minutes of heated tumbling followed by a 10-minute
(approx.) cooldown.
• Put just a few garments into the dryer.
• Set the Cycle Selector Control to TOUCH-UR
• Set the Heat Temp Control to the type of fabric in the load.
• Push the Start Control.
• Remove clothes immediately when tumbling stops.
TIMED DRY Cycle
Use this cycle to get up to 70 minutes of heated drying time. The heating
cycle is followed by a 10-minute (approx.) cooldown.
• Set the Cycle Selector Control to the amount of time you want in the
TIMED DRY Cycle.
• Set the Heat Tfemp Control to the type of fabric in the load.
• Push the Start Control.
SOFT-HEAT®
In the AUTOMATIC and TIMED DRY Cycles, clothes are dried at the
selected temperature until the last few minutes of the cycle when the dryer
switches to low heat. This helps prevent overdrying.
Lint Alert
Clean the lint screen before each load. If you do not, your dryer may not
operate properly. If enough lint accumulates to clog the lint screen, a con­
tinuous whistle tone will sound. Thm off the dryer, remove the lint screen,
clean and replace it. When the dryer is restarted the sound will stop.
Cooldown
Approximately ten minutes before the end of the AUTOMATIC and
TIMED DRY Cycles, clothes ate tumbled without heat to help reduce
wrinkles and make clothes more comfortable to handle.
Wrinkle Guard I
Wrinkle Guard I helps keep your permanent press items wrinkle free when
you cannot unload the dryer promptly at the end of the Automatic Cycle.
If you do not open the door at the end of the Automatic Cycle, Wrinkle
Guard I will tumble the clothes without heat for 30 minutes unless you
open the dryer door sooner. During Wrinkle Guard I the End-of-Cycle
Signal will sound after every 5 minutes unless the control is off.