Sears 536.9183 - Manual (Page 4)

CONTENTS OF SHIPPING CARTON
1 - 24 inch Snow Thrower (completely assembled except for
handles, controls and headlight).
1 - Can of Engine Oil
1 - Upper Chute Control Rod
1 - Left Hand Handle Assembly
1 - Right Hand Handle Assembly (with clutch lever attached)
1 - Control Panel Assembly
1 - Bag of Assembly Parts Containing:
1
2
10
4
4
2
2
8
8
1
1
1
2
¥t inch Flatwasher
- 5/16 inch Split Lockwasher
Formed (curved) Washers
No. 10
X 1/2 inch Hex Head Screws
No. 10 Locknuts
5/16 X 5/8 inch Hex Head Screws
5/16 X 1 inch Hex Head Screws
5/16 X 1% inch Hex Head Screws
5/16 inch Locknuts
Vs x % inch Hex Head Screws
Va inch Locknut
- Cable Clamp (metal)
Knobs (for Throttle and Impeller/Auger Drive Levers)
1 - Bag of Shear Bolt Replacement Parts (Not used in assem­
bly) Containing:
3 - 5/16 X m inch Shear Bolts
3 - 5/16 inch Locknuts
1 - Instruction Sheet
TOOLS REQUIRED FOR ASSEMBLY
1 - % inch Wrench (or adjustable wrench)
1 - 5/16 inch Wrench (or adjustable wrench)
2 - Vz inch Wrenches (or adjustable wrenches)
2 - 7/16 inch Wrenches (or adjustable wrenches)
2 - 9/16 inch Wrenches (or adjustable wrenches)
1 - Hammer (plastic or rawhide head recommended)
A DANGER A
The operation of any powered equipment can result
in foreign objects being thrown into the eyes, which
can result in severe eye damage. Always wear safety
glasses or eye shields while assembling or operating
Snow Thrower.
HANDLE ASSEMBLY
Right handle has a lever (power clutch) attached to upper
end. Nuts used to attach lower end of handles are attached to
inside of side frame.
1. Attach right lower handle to side of side frame as
shown in figure 2. Handle grip should be tilted down and out
when handle is properly installed,
'
2. Repeat step 1 for left handle.
Figure 2
SIDE FRAME
CONTROLS ASSEMBLY
1 . Attach control panel to handles as shown in figure 3.
NOTE: Attach panel with lower screw only on left side.
2. Attach chute deflector lever as shown in figure 3.
NOTE: Place a 5/16 inch flatwasher between lever
assembly and handle at top screw position.
ASSEMBLY
Your Snow Thrower is right or left hand as you face the unit
from operator position.
Figure 1 shows the Snow Throwercompletelyassembled.To
complete the assembly, proceed as follows;
RIGHT HANDLE Figure 3
A formed wesher is used on inside of handte at all screw locations.
3. To attach chute deflector cable bracket (attached to
cable), proceed as follows:
A. Place chute deflector lever in lowest (forward) notch.
B. Grasp chute deflector cable bracket and pull
down until a 5/16 x 1 % inch screw can be placed
through
bracket and through left handle as
shown in figure 3. NOTE: Only one of holes in
cable bracket is large enough for mounting screw.
4. Cable length will need to be adjusted if chute deflector
lever will not move all the way up to top notch in bracket or if
-4-