Operation – Sears 270-3250 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
Before starting the snow thrower, make sure you have read and performed the
steps in the “Preparing the Snow Thrower for Use’’ section of this manual. If you are
unsure about how to perform any of the steps in this manual please call (888) 315
3080 M-F 8-5 CTfor customer service.
Starting the Snow Thrower
To start up the snow thrower, perform the following steps:
1. Turn the engine fuel valve lever to the “on” position (see figure 8).
2. Move the choke lever to the closed position as shown in figure 7 (NOTE: If you
have just been using the snow thrower and the engine is still warm, keep the
choke in the “open” position).
3. Move the engine throttle lever to the fast position (see figure 8).
4. Move the engine switch to the “on” position as shown in figure 9.
s ir'n T.
i h. i
Figure 8 Engine lever positions
Figure 9- Engine switch positions
16