Set-up instructions, Specifications – Sears 247.8829 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SET-UP INSTRUCTIONS
Head this manuai in it'$ entirety before attempting to assemble or operate the Snow Thrower., The Snow Thrower
has been assembled at the factory with exception of those parts left unassembled for shipping purposes. All parts
such as nuts, washers bolts, etc., necessary to complete the assembly, have been placed ¡n the parts bag.
The following parts are included not assembled:
Loose Parts Bag (#14237^ Containing:
1 - Chute Rotation Control Rod
1 - Guide Bracket (Eye Boit)
2 - Hex Nuts 5/16-18
1 - Lock Washer 5/16"
1 - Cotter Pin
NOTE: Beforo assembling or operating unit, check for
damage and/or missing parts,
REFERENCE PHOTO
SPECIFICATIONS
U.L. Listed: Yes
Motor: 12 Amps 120 Volts A.C. (3HP Peak)
Wheels: 7.0 x 1.50 Rib Tread
Housing: Steel Construction - 21 in. wide
Handles: 7/8 in. 18 Ga. steel - Folding upper
Type: Auger Propelled
Auger: 9 in. dia. Steel with replaceable rubber
llightings.
This product is suitable for use wiUi a U.L. approved outdoor,
too toot, 2 or 3'Wire extension cord.
Exionsion cord jacket material should be made of rubber tor
ultimate flexibility and to prevent possible cracking under cold
weather conditions.
Extension cords are evaitable at your Sears store.
TOOLS REQUIRED FOR ASSEMBLY
Pliers and 1/2" or Adjustable Wrench
1. Remove the snow thrower and hose parts from carton and
p/ace unit on level work surface. Make certain all parts and
literature have been removed from the carton before the carton
is discarded.
2. Loosen the handkrmb on each side of the upper handle and
raise handle into operating position. Ttghlen hand knobs
securely.
3. CHUTB ROTATION CONTROL PODfSee Figs. 1A & 1B).
a) . Slide guide bracket (eyebolt) onto rod.
b) . Slip rod into universal joint, rotate rod to align holes and
insert cotter pin. With pliers, bend ends of coffer pin to
secure.
c) . Thread one (1)5/16-18nut ontoguide bracket (eyebolt)
to boffom of threads (Do not tighten).
d) . Insert guide bracket into hole in tower bandfe cross bar
from top side as shown.
e) . Assemble lock washer and remaining 5/16-78 nut to
guide bracket. Thread nut until approximately 1/8" of
threads extend out of fhe nut.
f) . Secure assembly to lower handle by tightening securely
the nut on top side of handle cross bar.
Pages
Fig. IB
Make certain all nuts and bolts elsewhere on unit are tightened
securely.