Sears KENMORE 53475 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

8. If tape tioids boHom drawer cover to drawer
supports, remove the tape Puli drawer partway out
Reach in, push the rear of the glass up and, at the some
time, bock, until it dears front-corner retainers

9. Tilt and remove the cover

10. Tilt and remove the drawer

After cieoning, replace drawers and covers in reverse
order Reinstall the gasket at the rear of the top drawer

Fit the end of the plastic
drawer support into the
slot on the gasket, with the
rubber gasket flap facing
you, Make sure the gasket
snaps into place

Then replace the light panel

by honging top of panel on
upper pins and pushing in
at bottom

Drain Opening in Freezer Compartmeni

When cleaning, remove
the freezer bin and flush

a solution of baking soda
(one teaspoon} and two
cups of hot (not boiling)
water through the droiri
line with the help of a
meat baster This will
help eliminate odor and
reduce the likelihood of a dogged drain line,

If drain becomes dogged, use a meat baster and
bakinq-soda-ond-water solution to force the cloq through

the drain line,

Condenser

The condenser is located
behind the base grille, For
most efficient operotion,
remove the base grille
and sweep away or
vacuum up dust that Is
readily accessible. For best

results, use a brush specially
designed for this purpose. It is available at your Sears
store or service center This easy cleaning operation
should be done at least once a yeor.

Behind Refrigerator

Take care moving your refrigerator owoy from the wall
All types of floor coverings can be damaged, particularly

cushioned coverings and those with embossed surfaces.
Pull the refrigerator straight out and return it to position by
pushing it straight in Moving refrigerator in a side direction
may damage floor covering or refrigerator.

Light Buib Replacement

Unplug the refrigerator before changing a light bulb.

Fresh Food Compartment-Upper Light

1. Puli off temperature control knobs

2. Puli the bottom of the light shield down and forward,
then rotate the top up and off

After replacing with same size bulb, reinstall light shield.

Fresh Food Compartment-Lower Light
(on some models)

This light is located behind a shield at the rear of
the fresh food compartment,

1. Grasp the top edge of the shield and lift it up

and forword to free its top edge

2, After replacing with same size bulb, hook the top
of the shield bock in place

Freezer Compartment

1. Remove shelf just below

light panel (Shelf will be
easier to remove if it is
emptied first |

2. Pul! plastic light panel
toward you. (It will bend to free tabs from grooves |

3. After replacing with same size bulb, reinstall panel
and shelf.

13

Advertising
This manual is related to the following products: