Sears 113.24611 - Manual (Page 10)

assembly
NOTE: When using motors which have 1/2 in. die.
shafts, place the adapter sleeve (furnished with the
motor) on the shaft so that the slot in the sleeve is over
the flat spot.
4. Insert the shaft key (furnished with motor) into the
grooves in the shaft and pulley so that the end of the
key is even with the end of the shaft.
5. Tighten the set screw. Use a pair of pliers on the short
end of the set screw wrench for increased leverage.
1/2 IN. DIA.
MOTOR SHAFT
3/16 X 3/16 KEY
FLAT SPOT
\
adapter sleeve
MOUNTING THE MOTOR
1. Position the motor mount as shown and place the
motor on top of it.
2. Find four 5/16 in.-18 x 3/4 in. CARRIAGE BOLTS,
flat washers and hex. nuts, among the loose parts.
3/4 IN.
h
j" 11/16 IN.—
^1
5/1Ó IN.
3. Insert the bolts as shown ... install washers . .. screw
on nuts but DON'T TIGHTEN them.
carriage
BOLT
4. Using a 5/32 inch set screw wrench unscrew the PIVOT
screws as shown.
PIVOT SCREW
10