Sears 53DS900078 - Manual (Page 2)

4. Drill 6 mounting holes in marked-off locations on the
wall. For wood wall mounting, drill 5/16-in. diameter
holes. For masonry wall mounting, drill 5/8-in, diameter
holes and insert 3/S-in. steel shields (anchors).
5. Assemble the bracket sections as shown in Fig. 2. using
bracket assembly bolts, lockwashers and bracket assembly
locknuts. Do not tighten the bracket assembly bolts until
the assembled kit is mounted on the wall. Mount the
bracket assembly to the wall as shown in Fig. 2, using the
6 wall lag bolts and washers provided. Once mounted,
tighten the bracket assembly bolts securely at all six
mounting locations.
6. Check that all bracket assembly sections are secure.
JL
CAUTION
EQUIPMENT DAMAGE HAZARD
Failure to follow this caution may result in equipment
and/or property damage.
To avoid damage to the wall or unit, check to be sure that
all accessory parts are fastened tightly before mounting the
unit on the wall brackets.
7. Mount the unit on the wall brackets using the 1-in.
mounting feet bolts and mounting feet locknuts provided.
Tighten with the mounting feet locknuts. Use 2 bolts on
the coil end of the unit, and 2 bolts beneath the
compressor section. See Fig. 2.
NOTE: For 38BN units only, a rubber spacer is provided to fill
space in the wall bracket channel underneath the mounting feet.
See Fig. 3.
Fig. 1 — Typical Installation