Before startino enoini (cdnt'd), Engine zone controi, Operation – Sears 917.383223 User Manual

Page 9: Imim

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

OPERATION

BEFORE STARTINO ENOINi

(CDNT'D)

GAS:

• Fill gasoline tank with fresh, clean unleaded

gasoline. DO NOT USE PREMIUM GASOLINE.

BE CAREFUL NOT TO OVERFILL TANK (SEE
FIG. 8).

WARNING: Experience indicates that alcohol blend­
ed fuels (called gasohol or using ethanol or methanol)

can attract moisture which leads to separation and

formation of acids during storage. Acidic gas can

damage the fuel system of an engine while in storage.

To avoid engine problems, the fuel system shouldoe
emptied before storage for 30 days or longer. Drain
the gas tank, start the engine and let if run until the
fuellines and carburetor are empty. Use fresh fuel

next season. See Storage Instructions for additional
information.
Never use engine or carburetor cleaner products in

the fuel tank or permanent damage may occur.

ENGINE ZONE CONTROi

A

CAUTION: FEDERAL REGULATIONS REOUiRI AN

ENGINE CONTROL TO BE INSTALLED ON THIS
LAWN liOWIR IN ORDER TO ffilNIiliZE THE
RISK OF BLADE CONTAG INJURY. DO NOT
UNDER ANY CISCOMSTANCES ATTIIWPT TO DE­
FEAT THE FUNCTION OF THE OPERATOR
CONTROI. THE BLADE TURNS WHIN THE ENGINE
IS RUNNING.

Your lawn mower is equipped with an Operator

Engine Control Bar whicn requires the operator

to be positioned behind the Lawn Mower Han­
dle to start and operate the lawn mower.

FIG. 8

TO START

imim

® To start a cold engine, push Primer five (5) times

before trying to start. Use a firm push. This step
is not usually necessary when starting an engine

which has already run for a few minutes.

® Push Engine Speed Control Lever forward to

HIGH position.

0 Hold Operator Presence Control Bar down to the

Handle and pull Starter Handle quickly. Do not

allow Starter Rope to snap back.

0 To STOP engine, release Operator Presence Con­

trol Bar.

NOTE: In cooler weather it may be necessary to
repeat priming steps. In warmer weather over prim­
ing may cause flooding and engine will not start. If
you do flood engine wait a few minutes before at­
tempting to start and DO NOT repeat priming steps.

383222

Advertising