Sears 944.529571 - Manual (Page 12)

OPERATION
TO THROW SNOW (See Fig. 14)
The auger rotation is controiied by the auger controi iever
iocated on the right side handle,
• Squeeze auger control lever to handle to engage the
auger and throw snow,
• Release the auger control lever to stop throwing snow.
USING THE CLEAN-OUT TOOL (See Fig. 15)
In certain snow conditions, the discharge chute may be­
come clogged with ice and snow. Use the clean-out tool
to dislodge this blockage.
When cleaning, repairing, or Inspecting, make
certain all controls are disengaged and the au-
ger/impellerand all moving parts have stopped.
Disconnect the spark plug wire and keep the
wire away from the spark plug to prevent ac­
cidental starting.
• Release the auger control lever and shut offthe engine,
• Remove the clean-out tool from it's mounting clip. Grasp
the tool firmly by the handle and push and twist the tool
into the discharge chute to dislodge the blockage.
After the packed snow has been dislodged, return the clean­
out tool to it's mounting clip by pushing it into the clip,
• Make sure the discharge chute is pointed in a safe direc­
tion (no vehicles, buildings, people, or other objects are
inthe direction of discharge) before restartingthe engine,
• Restart the engine, then squeeze the auger control
lever to the handle to clear snow from the auger hous­
ing and the discharge chute.
TO MOVE FORWARD AND BACKWARD (See Fig. 16)
SELF-PROPELLING, forward and reverse movement of
the snow thrower, is controlled by the traction drive control
lever located on the left side handle,
• Squeeze traction drive control lever to handle to engage
the drive system,
• Release traction drive control lever to stop the forward
or reverse movement of the snow thrower,
SPEED and DIRECTION are controlled by the drive speed
control lever,
• Press downward on the speed control lever and move
lever to desired position BEFORE engaging the trac­
tion drive control lever. Be sure lever springs back and
locks into desired position,
CAUTION: Do not move speed control lever
when traction drive control lever Is engaged.
Damage to the snow thrower can result.
• Slower speeds are for heavier snow and faster speeds
are for light snow and transporting the snow thrower. It
is recommended that you use a slower speed until you
are familiar with the operation of the snow thrower,
NOTE: When both traction drive and auger control levers
are engaged, the traction drive control lever will lock the
auger control lever in the engaged position. This will allow
you to release your right hand from the handle and adjust
the discharge chute direction without interrupting the snow
throwing process.
POWER STEERING OPERATION (See Fig. 17)
Steering triggers are used to assist in steering your snow
thrower. The triggers are located on the underside of each
handle. When a trigger is squeezed, it disengages the
drive wheel on that side of snow thrower and allows it to
turn in that direction,
• To turn left - squeeze left side trigger,
• To turn right - squeeze right side trigger.