To attach the handle, Electrical shock hazard, Plugging it in – Sears DieHard 200.71460 User Manual
Page 6: Warniimg
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Tap the other axle cap onto the opposite end of the
axle and place the axle assembly onto the bottom of
the charger. Place one end of the bracket into slot,
then place the axle assembly under each bracket.
Fasten the other side of the brackets using the two
10-32 screws provided.
To attach the handle:
Turn the charger right side up onto its foot and wheels.
Remove the two top screws from each side of the
charger and align with the screw holes on the handle.
Attach the handle using the same screws.
Plugging it in
A
warniimg
Electrical Shock Hazard
Be sure that power cord fits properly into outlet.
If not, have a qualified technician install a proper
outlet. Never alter the AC cord or plug provided.
Improper connection can result in electrical shock.
Your charger should be grounded to reduce the risk
of electrical shock.
Your charger is equipped with an electrical cord that
has an equipment grounding conductor and a ground
ing plug designed to be used on a 120 volt circuit. The
plug must be plugged into an outlet
that has been properly installed and grounded in
accordance with all local codes and ordinances.