User maintenance instructions, Care of surfaces, Protection against – Sears 14172 User Manual
Page 13: Freezing, Care of air gap, Preparation for moving, Protection against freezing
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
USER MAINTENANCE INSTRUCTIONS
CARE OF SURFACES
ean control panel with lightly
.ampened cloth. Dry thoroughly.
-DO NOT use abrasives or sharp
objects—they could damage the control
panel.
• Clean outside cabinet finish with a good
appliance polish wax. DO NOT use
scouring pads, harsh or gritty cleaners.
• Interior is self-cleaning with normal use.
If it should ever need cleaning, use a
mild cleansing powder. If hard water
causes lime build-up, clean as follows:
—Pour 2 cups white vinegar into empty
dishwasher. DO NOT use detergent.
—Operate machine on NORMAL WASH
cycle.
PROTECTION AGAINST
FREEZING
If dishwasher is left in an unheated place
during the winter:
• Shut off water and electrical power.
• Remove access panel.
• Disconnect water lines from valve. Drain
into a flat pan.
• Drain collection chamber at rear of unit
below filter by disconnecting hose to
pump.
• Remove plastic pump cover in tub
bottom and use sponge to soak up any
remaining water.
• Reconnect water lines to valve and
hoses to pump.
Pump cover screws ■
CARE OF AIR GAP
If an air gap was installed for your built-in
dishwasher, check to make sure it is
clean. Air gaps are usually mounted on
the countertop and can be inspected by
removing the cover. The air gap is not part
of your dishwasher and is not covered by
Sears warranty.
Drain air gap
PREPARATION FOR MOVING
• Disconnect electrical power.
• Turn off water supply, disconnect water
and drain lines.
• Tape racks in place; close door securely
and tape it shut.
• Wrap with blankets and, if using a hand
truck, lift dishwasher from side in upright
position only.