Sears KENMORE 46725 - Manual (Page 9)

DELAYEB mm AH© OFFi
You can set the oven to turn on and off automatically.
The control will calculate the time to start cooking.
1. Press COOK TIME.
2. Press UP or DOWN arrow to set how long you want
to bake.
3. Press STOP TIME. The earliest stop time you can set
will appear In the display.
4. Set STOP TIME (the time of day when you want the
oven to turn OFF) by pressing the UP or DOWN
arrow.
5. Press BAKE.
6. Select temperature by pressing UP or DOWN arrow.
See Fig. 8. ^
—1Í
iàiajà
Fig. 8
NOTE:
é®"' INCREASE OR DECREASE TIME®
INCREASE OR DECREASE®
TO SET STOP TIME T
INCREASE OR DECREASE (|)
TO SET TEMPERATURE
If the control beeps, you have not completed your timed
oven setting. Press CLEAR/OFF and start again with
Step 1,
The low temperature zone of this range
(between 150°F and 200°F) is available to
keep hot cooked foods warm. Food kept
longer than two hours at these low
temperatures may spoil.
A
Never let food, such as dairy products,
fish, meat, poultry, etc., sit for more
than 1 hour before cooking starts when
you set your oven for a delay start.
Room
temperature promotes the
growth of harmful bacteria. Be sure the
oven light Is off because heat from the
bulb will speed bacteria growth.
DISPLAY?
Once you have programmed your control for any
operation, you can display the setting by pressing the
appropriate pad. For example, if you are using the
TIMER and want to see the time of day, press CLOCK.
The display will show the time of day.
You cannot set BAKE, BROIL or COOK TIME while the
oven door Is In the locked position. If you try, the word
“door” will appear in the display. The oven door lock is
to be used for Self-Cleaning only.
TONES?
The end-of-cycle tone will sound at the end of timer use
and automatic oven functions. The end-of-cycle tone is
3 short beeps followed by 1 beep every 6 seconds that
repeat until you press any operation. If you would like
to eliminate the repeating beeps, push and hold CLEAR/
OFF for ten seconds. To return the 1 beep every 6
seconds, push and hold CLEAR/OFF for 10 seconds.
To cancel the end-of-cycle tone, press CLOCK.
F-CODE?
If the time display beeps continuously and flashes an
“F” followed by a number, you have a function error
code. Notethenumberafterthe“F”. Press CLEAR/OFF.
Allow oven to cool for 1 hour. If problem repeats,
disconnect all power to the range and cali for service.
Advise your service technician of the number following
the "F” in the display.
NCCTL17