Features, Q lint screen, Safety door switch – Sears 74291 User Manual
Page 4: B performance guide label, B model no. plate
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FEATURES
Q Lint Screen
Keep the lint screen clean. A lint-clogged screen will slow down the flow
of air. This makes drying time longer and wastes energy. Clean the lint
screen before each load as follows:
1. With dryer off, remove the screen by pulling straight up.
2. Roll the dry lint off the screen. Eto not wet the screen or lint; wet lint is
hard to remove.
3. Replace the cleaned lint screen.
AWARNING
Fire Hazard.
Do not use your dryer while the lint screen is removed.
It could cause overheating and possible damage to fabrics and dryer
parts or create a fire hazard. Lint screen must be pushed firmly into
place.
NOTE: If lint screen gets clogged by detergent or fabric softener build-up,
remove and clean it with a nylon brush, hot water and liquid detergent.
E)ry and replace screen.
Safety Door Switch
For safety, the switch shuts off dryer when door is opened. Dryer will not
start until door is closed and START is pushed. Be sure the Cycle Selector
Control is on a dry setting.
B Performance Guide Label
Located inside the dryer door. Gives information on what to do if dryer
does not perform normally.
NOTE: If dryer drum is stained, clean it with a damp cloth and mild
detergent.
B Model No. Plate
Shows model and serial numbers. Have these ready if you ever call for
service.
For more detailed drying times, rules for safe operation, fabric care,
maintenance and installation information, refer to the LAUNDRY
GUIDE and INSTALLATION INSTRUCTIONS you received with
your dryer.
Part No. 3392338 Printed in U.S.A.