Step 1 determine the header bracket location, Warning caution warning warning, Installation step 1 – Chamberlain 1300 User Manual

Page 12: Determine the header bracket location

Advertising
background image

12

INSTALLATION STEP 1

Determine the Header Bracket
Location

Installation procedures vary according to garage door
types. Follow the instructions which apply to your
door.

SECTIONAL DOOR
AND ONE-PIECE DOOR WITH TRACK

1. Close the door and mark the inside vertical

centerline of the garage door.

2. Extend the line onto the header wall above the

door.

You can fasten the header bracket within 4 feet
(1.2 m) of the left or right of the door center
only if a torsion spring or center bearing plate
is in the way; or you can attach it to the ceiling
(see page 10) when clearance is minimal. (It
may be mounted on the wall upside down if
necessary, to gain approximately 1/2" (1 cm).)

If you need to install the header bracket on a 2x4
(on wall or ceiling), use lag screws (not provided)
to securely fasten the 2x4 to structural supports as
shown here and on page 13.

3. Open your door to the highest point of travel as

shown. Draw an intersecting horizontal line on the
header wall 2" (5 cm) above the high point. This
height will provide travel clearance for the top edge
of the door.

Proceed to Step 2, page 14.

One-piece

door with

horizontal

track

To prevent possible SERIOUS INJURY or DEATH:
• Header bracket MUST be RIGIDLY fastened to

structural support on header wall or ceiling, otherwise
garage door might not reverse when required. DO NOT
install header bracket over drywall.

• Concrete anchors MUST be used if mounting header

bracket or 2x4 into masonry.

• NEVER try to loosen, move or adjust garage door,

springs, cables, pulleys, brackets, or their hardware, all
of which are under EXTREME tension.

• ALWAYS call a trained door systems technician if

garage door binds, sticks, or is out of balance. An
unbalanced garage door might not reverse when
required.

Header Wall

Ceiling

Track

Highest Point
of Travel

Door

2" (5 cm)

Sectional door
with curved
track

Door

Track

Header Wall

Highest Point
of Travel

2" (5 cm)

Finished
Ceiling

Header
Wall

2x4

Structural
Supports

Vertical
Centerline
of Garage Door

WARNING

CAUTION

WARNING

WARNING

Advertising