Cabletron Systems 2M46 - Manual (Page 91)

Module Level Security Configuration
Local Management Supplement 3-7
3.3 MODULE LEVEL SECURITY CONFIGURATION
The Module Level Security Configuration screen, Figure 3-3 , is used to
set the state of security according to connector. All repeater ports on a
connector can be set to receive all frames (NonSecure state), lock on the
source address of the next frame received (LockOnNext) or the source
address of the last frame received (LockedOnAddr). When either of the
last two options are set, the switch can be set to enable or disable the
reception of frames and send or not send traps when an intruder is
detected.
To access the Module Level Security Configuration screen, use the arrow
keys to highlight the MODULE LEVEL SECURITY
CONFIGURATION menu item on the Repeater Configuration Menu
screen and press ENTER. The Module Level Security Configuration
screen displays.
Figure 3-3 Module Level Security Configuration Screen
Connector Security State Action On Intruder
1 [LockOnNext] [DisablePort] [SendTrap]
2 [PortMismatch]
3 [NonSecure]
4 [LockedOnAddr]
[DisablePort] [SendTrap]
SAVE EXIT RETURN
2276_112w