Connect Tech 104 - Manual (Page 6)

Connect Tech FlashDrive/104 User's Manual Revision 0.08
2
Board Overview
Figure 1: FlashDrive/104 Layout
Table 1: FlashDrive/104 Components
Location Description/Function
P9 Master / Slave Selection and Write Protect
P8 ATA/IDE 0.100” Connector
P1 ATA/IDE 2mm Connector
DDG/ DEG: pins 41 & 42 are connected to 5V
DGG: pins 41 & 42 are not connected
P2 Diagnostic Header (Connect Tech use only)
P6, P7 PC/104 Connector – specifications available from the PC/104 Consortium
P5 PCI-104 Connector -specifications available from the PC/104 Consortium
P3 Power Connector:
Pin Signal
1 N/C (+12 V on cable)
2 N/C (GND on cable)
3 GND
4 +5V
NOTE: P5, P6 and P7 are used with mechanical stack throughs only. P3 provides power over
standard PC disk drive power connectors (5V only)