Threading the bobbin case – SINGER 1263 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Threading the Bobbin Case
1. Hold bobbin so that thread unwinds in direction
shown, and insert bobbin in bobbin case.
2. Pull thread into notch A in bobbin case, draw it
toward left and into slot B.
3. Draw approximately 10cm (4 inches) of thread diag
onally across the bobbin.
4. Close slide plate, allowing thread to extend through
the slot between the slide plate and the needle plate.
20
Advertising