Replacement bobbins, Bobbin winding, Bobbin winding 2 - 2 4 – SINGER 384.13012 (Sold at Sears) User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Replacement Bobbins
Only use bobbins purchased through Sears Stores, stock No.
6870 or Sears Service Centers, Parts No. 102869107.
Bobbin Winding
• Removing bobbin case
Remove the extension table from the machine by pulling it to
the left. Open the shuttle coverQby pulling down the
embossed part on the left of the cover.
Raise the needle to its highest position by rotating the
handwheel toward you.
0 Shuttle cover
(2) Bobbin case
To remove the bobbin case(|)from the shuttle, pull open the
latch of the bobbin case. Pull the bobbin case straight out of
the shuttle.
• Bobbin winding
m Release the clutch by pulling out the handwheel. This
will stop the needle from moving while you wind the
bobbin.
H] Draw thread from spool.
[si Guide the thread around the thread guide.
[
a
] Thread through the hole in the bobbin from the inside to
the outside.
H] Put the bobbin on the bobbin winder spindle.