Shaping darts in interfacings – SINGER W711 User Manual
Page 40
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
40
SHAPING DARTS IN INTERFACINGS
Fig.
0
3
%
c
/¿if
Center
"
1'
interfacina
down center
Cut interfacing down center between aart
Overlap cut edges, matching cart lines. Zigrag _
along marking line from point to wide end o*
Trim both raw edges close to stitching.
Cf
ones,
stitcli
aart.
Most fabrics need to be guided only in front of the presses foot as shown at left. Many fil
sheers, crepes, knits, tricots, etc., require support while being stitched. For such fabric use ■
straight stitch throat plate and presses foot and apply gentle tension by holding seam in front a
back of the presses foot as shown at right.
Advertising