Four-step buttonholing (cont’d.), Changing stitch density – SINGER 4314 User Manual
Page 35
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FOUR-STEP BUTTONHOLING (Cont’d.)
Step 3: Bar Tack
Raise the needle above the fabric.
Turn buttonhole dial
clockwise
to step
3.
Take at least four stitches ending
at point
D.
Step 4: Side Stitching
Raise the needle above the fabric.
Turn buttonhole dial
clockwise
to step
4.
Stitch until the side stitching meets
the bar tack at point
E.
CHANGING STITCH DENSITY
Stitch
density
on
left
and
right
sides
of
the
buttonhole
may
be
balanced
by
using
the
stitch
balance
dial.
Use
the
stitch
balance
dial
to
obtain
similar
stitch
appearance
on
either side of the buttonhole.
To change the density on either side of the buttonhole follow the procedure below.
Return the balance dial to its neutral position after buttonhole sewing is completed.
THEN DO THIS
RESULT
Stitches on the
l e f t
side are
too far apart
Similar stitch
appearance on
either side of
the buttonhole
THEN DO THIS
RESULT
Stitches on the
r i g h t
side are
too far apart
Similar stitch
appearance on
either side of
the buttonhole
33