Replacing slide plate, Changing the light bulb – SINGER 6136 User Manual
Page 41
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REMOVING FACE PLATE
Loosen screw A {do not remove).
Loosen face plate screw B then remove
face plate by drawing it toward you. Re
place face plate by sliding top edge of
plate linder edge of arm top cover. Tighten
screws 8 and A.
REPLACING SLIDE PLATE
Place slide plate in slide way with the front
edge close to. but not covering, the retain
ing spring C. With a small screwdriver, lift
each end of the spring into each of the side
grooves on the under side of the slide plate.
Draw the slide plate gently toward you to
engage the spring. Close slide piate.
CHANGING THE LIGHT BULB
CAUTION: Before changing light bulb make CAUTION: This machine is designed to use
sure you have disconnected power lino plug a 15 watt maximum bayonet base bulb only.
from socket outlet.
Removing Bulb
Replacing Bulb
♦ Remove face plate.
♦ Do not attempt to unscrew the bulb.
♦ Press it up into the socket and at the
same timo turn bulb over in direction
shown to unlock the buib pin and guide
out of socket.
• Turn it over in direction shown to lock
buib in position.
♦ Replace face plate.
39