SINGER 6110 - Manual (Page 40)

REMOVING FACE PLATE REPLACING SLIDE PLATE
Loosen screw A (do not remove).
Loosen face plate screw B then remove
face plate by drawing it toward you, Re­
place face plate by sliding top edge of
piate under edge of arm top cover. Tighten
screws B and A.
Place slide plate in slide way with the front
edge close to, but not covering, the retain­
ing spring C. With a smali screwdriver, lift
each end of the spring into each of the side
grooves on the under side of the slide piate.
Draw the slide piate gently toward you to
fully engage the spring. Close slide plate.
CHANGING THE LIGHT BULB
CAUTION: Before changing light buib make
sure you have disconnocted power line plug
from socket outlet
Removing Bulb
CAUTION: This machine is designed to use
a Id waft maximum bayonet base bulb only.
Replacing Bulb
* Remove face plate.
• Do not attempt to unscrew the bulb.
♦ Press it up into the socket and at the
same time turn bulb over in direction
shown to unlock the bulb pin and guide
out of socket.
• Press new bulb into socket, with bulb
pins entering slot of socket.
• Turn it over in direction shown to lock
buib in position.
• Replace face plate.
39