Winding the bobbin, Flat side, Inserting the needle – SINGER W1222 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
See Fig. 2. Raise the needle bar ® to its highest point, turning
hand wheel toward you by hand. Then loosen the needle clamp
screw ® and the needle can be inserted into clamp (3).
Place needle (Fig.3, FLAT SIDE TO RIGHT) in the needle clamp
and push it upward as far as it will go into the needle clamp hole,
tightening the needle clamp screw securely with a screw driver.
After changing the needle, make one complete revolution of the
hand wheel by hand to be sure the needle is in the correct position.
INSERTING THE NEEDLE
Fig. 2
WINDING THE BOBBIN
flat side
Fig. 3
Disengage the hand wheel CCD, Fig. 4) from the stitching
mechanism by turning the clutch (®, Fig. 4) toward you or counter
clockwise. Place a spool of thread on one of the spool pins and lead
thread around one set of arm thread guide ((D, Fig. 4). Run end of
thread through a hole in the bobbin edge and place bobbin on
spindle of bobbin winder (©, Fig. 4) fitting the notch on bobbin
over small pin on spindle. Push bobbin winder lever (®, Fig. 4)
against bobbin. Hold thread end loosely and start machine slowly.
Bobbin will stop winding when it is filled.
Turn clutch away To reengage stitching mechanism turn clutch
(CD,
Fig 4) clockwise.