SINGER 177 User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3. Place bobbin on spindle and slide bobbin
and spindle to the right.
4. Hold thread end and start the machine.
(Thread end will break off after a few coils
have been wound.)
5. When bobbin is slightly less than full, stop
the machine and slide bobbin and spindle
to the left. Cut thread about four inches from
the bobbin and remove bobbin from spindle.
6. Hold the hand wheel from turning and tighten
hand wheel knob.
The bobbin-winding tension has been pre-set
at the factory and should need no adjusting.
However, if adjustment is required, loosen the
screw that holds the bobbin-winder tension
bracket to the machine and slide the bracket
forward if bobbin winds high to the rear; slide
bracket back if bobbin winds high to the front.
Winding steps (continued)
12