Cisco 10BASE-FL User Manual
Page 29
PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Configuration 29
Installing or Replacing a Port Adapter in Cisco 7200 Series Routers
Step 7
Move the port adapter lever to the locked position. Figure 19 shows the port adapter lever
in the locked position.
Note
If the port adapter lever does not move to the locked position, the port adapter is not
completely seated in the midplane. Carefully pull the port adapter halfway out of the slot, reinsert it,
and move the port adapter lever to the locked position.
Figure 19
Placing the Port Adapter Lever in the Locked Position (Cisco 7206 shown)
This completes the procedure for installing a new port adapter in a Cisco 7200 series router.
ETHERNET 10BT
ENABLED
0
2
1
3
LINK
0
1
2
3
FAST SERIAL
EN
TD
TC
RD
RC
LB CD
TD
TC
RD
RC
LB CD
TD
TC
RD
RC
LB CD
TD
TC
RD
RC
LB CD
ENABLED
MII
LINK
RJ45
FAST ETHERNET
0
TOKEN RING
0
1
2
3
0
2
4
1
3
5
6
H6747
MII
EN
RJ45
EN
RJ45
LINK
1O PWR
OK
RJ-45
CPU RESET
FAST ETHERNET INPUT/OUTPUT CONTROLLER
ENABLED
PCMCIA
EJECT
SLOT 0
SLOT 1
FE MII
Port adapter
handle
Port adapter
lever (locked
position)
Note: This adapter installation
applies to any port or service
adapter.