Identification (what is what, Identification of symbols – Husqvarna 141 EN User Manual
Page 2
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
IDENTIFICATION (WHAT IS WHAT?
1. Cylinder Cover .........
13. Bar Tip Sprocket .......... :
2.
Front Handle .......... :
14. Saw Chairi \
3.
Front Hand Guard /
■■■■ ■■■...........15. Saw Bar .... ■.. ■■■■ ■■■ ■■ ■■. ■................... ■■■■.. ■■. ;..
4.
Starter Cover : : '
...........16. Chain Catcher .................. ...............
5. Chain Oil Tank ......... :
............17. Chain Brake Assembly ^ ^
6.
Starter Handle .......... ........................ ............18. Rear Hand Guard............. -
7.
Carburetor Adjusting Screw............... ............19. Throttle Control/Trigger ........................
8.
Choke Control ................................... ............20. Throttle Lock ............ ................ ..........
9.
Rear Handle ............... ...................... ............21. Bar/Chain Adjustment Tool....................
10. ON/OFF Stop Switch ......................... ............22. Chain Tensioning Screw........................
11. Fuel Tank........................................... ............23. Instruction Manual.................................
12
Muffler............................................... ............24. Guide Bar Cover....................................
IDENTIFICATION OF SYMBOLS
WARNING!
This chain saw can be dangerous! Careless or improper
use can cause serious or even fata! injury.
Read and understand the instruction manual before using the chain saw.
Measured maximum kickback value without chain brake for the bar and
chain combination on the label.
There may be more symbols found on your unit other than those listed above. These
symbols may represent compliances, standards, or other matters concerning the product.