Crimestopper Security Products COOL START RS-900 - Manual (Page 11)

2-VEHICLE OPERATION
A single RS-900VII remote can control two different
vehicles with RS-900VII systems installed.
COOLSTART
VEHICLE #2
Press side button
first, then you have
4 seconds to
control vehicle #2.
SETUP:
Follow the “Transmitter Programming” steps on the second
vehicle. Program Car #2’s existing remotes, then quickly
press the Car #2 side button on your remote before
pressing the lock button on your remote to program it to
Car #2. Once your remote is programmed to the second
vehicle, press the car #2 side button on your remote first,
and within 3 seconds press any of the 4 function buttons
on your remote. You can keep pressing function buttons to
control car #2 as long as it is within the 3-second window.
After 3 seconds have elapsed, the remote will revert back
to Car #1 control.
TROUBLESHOOTING: “BEFORE YOU CALL” SECTION
UNIT WILL NOT ATTEMPT A START (KEYLESS ENTRY STILL FUNCTIONS NORMALLY):
The unit is in Valet mode. Turn Ignition ON, press and hold valet/programming button for 6 seconds then turn key
off. Unit is now out of valet mode and should perform a remote start. If optional LED indicator is installed, then it
will be on solid when in Valet and OFF when out of Valet.
UNIT FLASHES LIGHTS ONCE AND WILL NOT ATTEMPT A START:
The unit senses a fault at the Brake (Purple wire is active) or the Hood is OPEN (Gray wire grounded). This is a
safety feature of the unit. Check installation for faults and make sure hood is closed and latched and brake wire is
not active. Make sure hood is in good condition and is depressed when hood is closed.
NO RESPONSE FROM REMOTE TRANSMITTERS: (4 Parts)
1. Check for proper power/ground wiring connections at module.
2. Check Antenna Module connection. The antenna module included with this system must be plugged in.
3. Transmitters may need to be programmed to the unit. See transmitter programming steps on Page 10.
4. Check transmitter Batteries and replace if necessary.
11