Compaq MICROSPACE MSEBX900 - Manual (Page 26)

DIGITAL-LOGIC AG MSEBX800/900 Detailed Manual V1.0
26
3.3. RAM Assembly/Disassembly
To install or change the RAM, follow these steps:
1. Unmount the smartModule by removing the 4 screws marked in red (see the photo from the previous
page).
2. To change the RAM:
a. Using your thumbnails, gently push the clips holding the RAM module in place toward the
outside (Photo 1, marked "A").
Photo 1
b. There will be a slight "click" and the RAM will flip up at an angle (Photo 2).
Photo 2
c. Remove the original RAM.
d. With the new RAM, carefully place the side with the connectors into the slot. There is only one
correct way to place the RAM in the slot due to a notch between the connectors which matches
up to a tab in the slot. Do not force the RAM into the slot, it should fit very easily.