MTD 240-623-003 - Manual (Page 10)

USING THE LOG SPLITTER
Use the log splitter only on a level, hard surface.
Never stand next to the splitting wedge 'vhen
operating the log splitter. Always stand behind the
reservoir tank.
See figures 14 and 15. Never attempt
to cut a log in half sideways. Always split th3 log
lengthwise. Maximum length of log to be split is 24".
If all logs are of a smaller length, refer to “Log
Dislodger” in Adjustment Section (Model 424/LCD/22
Only).
Control
A
i WARNING i
Always use the log splitter in the
vertical position only
when splitting
heavy logs.
The control handle has three positions:
FORWARD—Push the control handle down for vortical
operation, push it forward for horizontal operalion—
Splitting wedge moves toward the end plate. Con­
trol handle will return to neutral position as soon as
handle is released.
NEUTRAL (Middle position)—Splitting wedge stops
in place.
REVERSE—Push the control handle upward fcr ver-
ical operation, push it toward the rear for hori;:ontal
operation—Splitting wedge returns. The control han­
dle will lock in the reverse position, and will letum
to neutral automatically when the reverse stroke is
complete.
TO OPERATE LOG SPLITTER:
1. Set throttle at maximum speed.
2. Place the log upright, on top of end plate for ver­
tical operation, and on top of beam for horizontal
operation.
3. Push the control handle in forward position until
the splitting wedge just contacts the log. Release
the control handle.
4. Step behind the reservoir tank (see figures 14
or 15) and push the control handle in forward posi­
tion until the log is split.
5. Move the control handle to reverse position to
return the splitting wedge.
A.
WARNING
If the fluid becomes excessively hot at
any time during operation, stop the unit
and allow the fluid to cool down. Maxi­
mum performance will not be obtained
from your log splitter if the fluid is too
hot. Use extreme caution as contacting
hot fluid could result in serious personal
injury.
TO TRANSPORT LOG SPLITTER
1. Lower the beam to its horizontal position. Make
certain the beam is latched securely with the lock­
ing rod.
2. Remove the quick release pin which secures the
jack stand. Pivot it up against the tongue, and
secure with the quick release pin.
10