Poulan XC1182B - Manual (Page 19)

SERVICE AND ADJUSTMENTS
A CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
Depress clutch/brake pedal fully and set parking brake.
Place gear shift lever in “NEUTRAL” position.
Place attachment clutch in “DISENGAGED" position.
Turn ignition key “OFF” and remove key.
Make sure the blades and all moving parts have completely stopped.
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
plug.
TRACTOR
TO REMOVE MOWER (See FIG. 2 2 }
Mower will be easier to remove from the right side of unit.
• Remove mower drive belt from electric clutch pulley only
(See “TO REPLACE MOWER DRIVE BELT’through step
removing belt from electric clutch pulley).
• Pul! retainer springs out of rear suspension trunnions.
Remove rear suspension trunnions from lift brackets.
• Pull retainer springs from front hinge pins.
• Remove hinge pins attaching parallel link to mower and
front axle.
• Raise lift leverto raise suspension arms. Slide mower out
from under tractor.
IMPORTANT: IF AN TT- a CHMENT OTHER THAN THE
MOWER IS TO BE MOUNTED TO THE
TRACTOR, THE R.H. AND LH. SUSPEN­
SION ARMS MUST BE REMOVED FROM
FiG. 22
TO INSTALL MOWER
See “ilMSTALL MOWER” in the assembly section of this
manual.
TO LEVEL MOWER HOUSING
Adjust ‘he i 'ciwei wt-li iftor
driveway t fct >■
- ' ^
UCTSPEC'i OF R
derinflatcd, /o . vli vb
pa-Wd f I , ' / e i giou'-'d t,
•'e, j ,S,.v 'i- ’
’
Uiffc-a*'f- . '■'! i ru .
/ adiust your mo’wer.
SIDE-TO-SIDE ADJUSTMENT (See FIGS. 23 and 24)
• Raise attachment lift lever to its highest position.
• Measure height from bottom of deck curl to ground level at
front corners of mower. Distance “A” should be the same.
FiG. 23
• If distance “A” needs to be changed, snap out access hole
cover on left side of tractor above footrest.
• To raise left side of mower, loosen nut “B" and tighten nut
“C”.
• To lower left side of mower, loosen nut “C” and tighten nut
“B”.
• When distance “A” is equal, securely tighten nuts “B” and
“C”.