Assembly, Unpack carton & install handle (see fig. 2), Install reverse rod (see fig. 2) – Poulan 174102 User Manual
Page 5: Install depth stake asstwdly, See fig. 3), Handle height, Tilling width, Tine operation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
UNPACK CARTON & INSTALL HANDLE (See
Fig. 2)
A
C AUl iON, Be careful of exposed staples
when handling or disposing of cartonirig
material.
IMPORTANT:
WHEN UNPACKING AND ASSEMBLING
FILLER. BE CAREFUL
NOT TO
STRETCH OR KINK
SABLE(S).
' Cut cable ties securing handles.
•
Slowly lift handle assembly up and align handle holes
with handle panel hole and slot.
» Loosely assemble hardware as shown. Be sure the
shorter (3/4" long) hex bolt is assembled in lower hole of
handle. Repeatfor opposite side. Tighten all hardware
securely.
•
Cut cable ties securing tiller to skid and remove tiller
from skid.
INSTALL REVERSE ROD (See Fig. 2)
•
Secure upper reverse rod to lower reverse rod using
clevis pin. Secure with cotter pin.
I N S T A L L D E P T H S T A K E
A S S t W d L Y
(See Fig. 3)
•
Loosen nut “A”.
•
Insert stake support between engine bracket halves with
stake spring down.
•
Bolt stake support to engine brackets with bolts, lock
washers and nuts. Tighten securely. Tighten nut “A”.
•
Depth stake must move freely. If it does not, loosen
support bolt.
HANDLE HEIGHT
•
Handle height may be adjusted to better suit operator.
(See “HANDLE HEIGHT” in the Service and Adjust
ments section of this manual).
TILLING WIDTH
• Tilling width may be adjusted to better handle yourtilling
conditions (See “TINE ARRANGEMENT” in the Service
and Adjustments section of this manual).
TINE OPERATION
•
Check tine operation before first use. (See “TINE
OPERATION CHECK” in the Service and Adjustments
section of this manual).
FIG. 2